Home » Home DIY Repair » Washing Machine Repair » Whirlpool HE Duet Front Load Washing Machine Error Codes

Whirlpool HE Duet Front Load Washing Machine Error Codes

Whirlpool Duet HE Front Loading Washer Error Codes. The following error code list explains each error code that can display on your Whirlpool HE Duet Front Load Washing Machine. The videos below will show you how to get into diagnostic mode if needed. Be sure to use the following error codes with the correct model number Whirlpool Duet Front-Loader Washer.

Whirlpool HE Duet Front Load Washing Machine Error CodesWhirlpool HE Duet Front Load Washing Machine Error Codes

Here is the Whirlpool Washer Service Manuals & Literature page, simply enter your washer model number for the full PDF manual.

More Whirlpool Washer error and fault code pages here… Whirlpool Duet Washing Machine Error Codes – Fault Code DefinitionsWhirlpool Washer Front Load Error Codes – What Does Error Code Mean And How To FixWhirlpool Cabrio Washing Machine Error CodesWhirlpool Washing Machine Error Fault CodesWhirlpool Washer Error Code F21 – DRAINING ERROR – How To Fix, and Whirlpool Duet Washer Error Code E01 F09 – How To Fix – How To Clear.



Whirlpool Duet Washer Diagnostics & Error Codes

 


Whirlpool Washing Machine Error Codes Diagnosis

NOTE: Remember to remove power to your washer before any troubleshooting!

Whirlpool HE Duet Front Load Washing Machine Error Code = E01 F09 or F9/E1
Whirlpool Error Code Explanation: Long Drain – The drain time has exceeded 8 minutes, the valves turn off, and the drain pump will stop.
What To Check / Fix / Clean / Replace:
-Check that the drain hose is not blocked or kinked.
-Be sure drain hose is not sealed into drain pipe.
-Check that the drain hose height does not exceed 96″.
-Check and or clean the drain pump filter.
-Check connections on pressure sensor.
Check / Adjust / Clean / Replace: Adjust, Tighten, or Clean Components

Whirlpool HE Duet Front Load Washing Machine Error Code = F/H
Whirlpool Error Code Explanation: Not filling with water
What To Check / Fix / Clean / Replace:
-Are both water supply valves behind the washer fully open?
-Check the drain system for a siphon problem.
-If the water inlet valve assembly is faulty simply replace it.
Check / Adjust / Clean / Replace: Water inlet valve assembly

Whirlpool HE Duet Front Load Washing Machine Error Code = F/02
Whirlpool Error Code Explanation: Takes long time to drain water
What To Check / Fix / Clean / Replace:
-Remove excess suds.
-The washer cannot drain extreme sudsy water.
-Unplug the washer and check the large item filter in the drain pump for a blockage.
-If the drain pump is defective simply replace it.
Check / Adjust / Clean / Replace: Drain pump

 

Whirlpool front load washer parts and accessoriesWhirlpool front load washer parts and accessories

 

Whirlpool HE Duet Front Load Washing Machine Error Code = F/05
Whirlpool Error Code Explanation: Water temperature sensor
What To Check / Fix / Clean / Replace:
-Unplug the washer and check the wiring going to the water temperature sensor.
-If the wiring is sound then replace the temperature sensor.
Check / Adjust / Clean / Replace: Temperature sensor

Whirlpool HE Duet Front Load Washing Machine Error Code = F/06
Whirlpool Error Code Explanation: Motor tachometer
What To Check / Fix / Clean / Replace:
-Unplug the washer and check the wiring between the motor control board and the drive motor.
-Check the wire harness connection between the motor control board and the main control board.
-If the wiring connections check good, the drive motor or the motor control board may be faulty.
Check / Adjust / Clean / Replace: Drive motor – Motor control board

Whirlpool HE Duet Front Load Washing Machine Error Code = F/09
Whirlpool Error Code Explanation: Water overflow
What To Check / Fix / Clean / Replace:
-The drain pump runs constantly in an effort to drain the water.
-Unplug the washer and, if the washer is overfilled, check the water inlet valve assembly for proper shut-off of water flow.
-If the water inlet valve assembly is defective simply replace it.
-If the washer is empty when this error code appears then replace the water-level pressure switch.
Check / Adjust / Clean / Replace: Water inlet valve assembly – Water-level pressure switch.

Whirlpool HE Duet Front Load Washing Machine Error Code = F/10
Whirlpool Error Code Explanation: Motor control board overheated
What To Check / Fix / Clean / Replace:
-Unplug the washer and check the wiring connections on the motor control board.
-Check the drive system for problems.
-If the wiring and the drive system are sound, the motor control board usually needs to be replaced.
Check / Adjust / Clean / Replace: Motor control board – Wiring harness

Whirlpool HE Duet Front Load Washing Machine Error Code = F/11
Whirlpool Error Code Explanation: Serial communication error with main electronic ontrol board and motor control board
What To Check / Fix / Clean / Replace:
-Check the connections on the main control board, motor control board and drive motor.
-If there are no connection problems, the motor control board and/or the main control board may need to be removed and replaced.
Check / Adjust / Clean / Replace: Main control board – Motor control board – Wiring harness

Whirlpool HE Duet Front Load Washing Machine Error Code = F/13
Whirlpool Error Code Explanation: Dispenser circuit error
What To Check / Fix / Clean / Replace:
-The dispenser can’t move into position.
-You will hear the dispenser system shifting before this code is shown.
-Unplug the washer and check the mechanical linkage on the dispenser housing.
-Repair or replace any damaged parts.
Check / Adjust / Clean / Replace: Dispenser assembly parts

Whirlpool HE Duet Front Load Washing Machine Error Code = F/14
Whirlpool Error Code Explanation: Main control board EEPROM error
What To Check / Fix / Clean / Replace:
-The Electrically Erasable Programmable Read-Only Memory (EEPROM) on the main electronic control board is corrupted.
-Unplug the washer for 5 minutes, restore power and see if the code clears.
-If not then replace the main electronic control board.
Check / Adjust / Clean / Replace: Main electronic control board

Whirlpool HE Duet Front Load Washing Machine Error Code = F/15
Whirlpool Error Code Explanation: Motor control board error
What To Check / Fix / Clean / Replace:
-Unplug the washer.
-Check the wire harness connections on the motor control board.
-Make sure that the drive motor connections are secure.
-If there’s no wiring connection problem, the motor control board may need to be replaced.
Check / Adjust / Clean / Replace: Motor control board

Whirlpool HE Duet Front Load Washing Machine Error Code = SUD or Sud
Whirlpool Error Code Explanation: Excessive suds
What To Check / Fix / Clean / Replace:
-If you see excessive suds in the washer start using the proper high-efficiency (HE) detergent.
Check / Adjust / Clean / Replace: (HE) detergent

Whirlpool HE Duet Front Load Washing Machine Error Code = F/dL
Whirlpool Error Code Explanation: Door lock error
What To Check / Fix / Clean / Replace:
-The door can’t lock.
-Check the door lock assembly for damage or a loose wiring connection.
-If there are no issues, you may need to replace the door lock assembly.
Check / Adjust / Clean / Replace: Door lock assembly

Whirlpool HE Duet Front Load Washing Machine Error Code = F/dU
Whirlpool Error Code Explanation: Door unlock error – The washer won’t unlock
What To Check / Fix / Clean / Replace:
-Check the door lock assembly for damage or a loose wiring connection.
-If there are no problems, you may need to replace the door lock assembly.
Check / Adjust / Clean / Replace: Door lock assembly

 


Whirlpool washing machine drain pump replacement and diagnostic

 

For Whirlpool DUET Front Load Washers MODELS: WFW8300SW, WFW8500SW, WFW8500SR.. See the error charts below…

Whirlpool DUET Front Load Washers MODELS WFW8300SW - WFW8500SW - WFW8500SR error code charts 1Whirlpool DUET Front Load Washers MODELS WFW8300SW - WFW8500SW - WFW8500SR error code charts 3Whirlpool DUET Front Load Washers MODELS WFW8300SW – WFW8500SW – WFW8500SR error code charts

Need help? Leave a question below and we will assist.

Leave a Reply

1 thought on “Whirlpool HE Duet Front Load Washing Machine Error Codes”

  1. I have a 3 yr old Whirlpool Duet and it is constantly throwing error codes: F05 E02
    I Reset then turn it back on and it is fine, load up a small wash, hit Quick Wash, start and with in 30 sec, Click, door locks it then Throws another Error: F08 E02
    I have pulled popped the hood and on all the wiring harness connectors used ‘switch cleaner’ on all the connections thinking it was maybe a croided socket/connector, pulled all the connectors off one by one and used CrC Switch Cleaner, and reinstall plug(s) to there married sockets. I also looked in the ‘Catch trap’ there was nothing in there apart from some water in the pipe.

    Reinstalled cover to Trap. put machine upright plugged in, hit pwr on and no errors… runs fine for 2 days.
    On the 3rd day I get Beep Beep Beep…. Beep beep beep… F05/E02 Beep beep beep. Beep beep beep. F02/E02 flashing on the display again?
    What’s the issue would possibly be?

Leave a Comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.