Find your dryer heating element. My dryer heating element went out. My clothes dryer does not heat and I have tested the elements. I have 2 different dryers (Samsung and Whirlpool) that both need heating element replacements. Our dryers get used multiple times a day. I went to home depot and lowes and did not find the elements I needed. I need to find the correct heating elements for my dryers to get them heating and drying again.
Dryer Heating Elements For Most Dryers
Below you will find common Admiral, Amana, Asko, Beko, Bosch, Electrolux, Fisher & Paykel, Frigidaire, GE, Hotpoint, Kenmore, KitchenAid, LG, Magic Chef, Maytag, Samsung, Sears, Sharp, Speed Queen, and Whirlpool dryer heating elements for most dryer models.
Amana Dryer Heating Element

Bosch Dryer Heating Element

Fisher & Paykel Dryer Heating Element

Frigidaire Dryer Heating Element

GE Dryer Heating Element


GE WE11X10007, WE11X10007C, WE11M23, AP2620171, PS265605
LG Dryer Heating Element

Maytag & Magic Chef Dryer Heating Element

Whirlpool, Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper

Roper Dryer Heating Element

Samsung Dryer Heating Element

Dryer Repair Kit with DC47-00018A Thermostat
DC47-00016A & DC96-00887A
Thermal Fuses and DC32-00007A Dryer Thermistor


Whirlpool & Kenmore Dryer Heating Element

(Replaces 279218, 279247, 279248, 279410, 279411, 279455, 279478, 279598, 279698, 337378)

Thermal Cut-off Fuse Kit Replacement Blue Stars Whirlpool Kenmore Dryers


Whirlpool Kenmore Sears Maytag KitchenAid Magic Chef
How To Replace a Heating Element | Whirlpool Dryer Repair
Samsung Dryer Heating Element Replacement
Removing a heating element will vary slightly with different models of dryers. To be sure of the exact install for your dryer model number please consult the dryer service manual.
How to Change the Heating Element in a Dryer?
- Remove power from dryer.
- Remove the screws on the back or front of the dryer.
- Remove dryer cover/panel.
- Find where the heating element housing is located inside the dryer.
- Remove screws that hold the heating element housing.
- Take the heating element and housing out of the dryer.
- Disconnect wiring that goes to dryer from element but do not remove the wires from thermostat or high limit switch.
- Use an Ohm meter on the two leads of the element to confirm if the element is bad.
(If the element is found to be faulty, continue below, if not faulty, continue troubleshooting) - Remove the screws holding the thermostat and high limit switch from housing.
- Remove the screws that hold the heating element housing together.
- Separate and remove the heating element from the housing.
- Replace it with the new heating element and follow the steps in reverse to install.
NEED HELP? Simply ask your question using the comments form below (It is free and you do not have to register) and we can troubleshoot your DRYER problem.
