I have a Whirlpool Cabrio washer about a year old. When I run a wash cycle it gets stuck in constant loop of wash cycles going on and on. The washer would begin to soak the clothes right after the spin cycle and then go through the entire wash cycle once again. To stop this I had to turn the washer off. Is there a reset I could follow to stop the endless wash cycle or do I need to replace parts?
Whirlpool Cabrio Washer Stuck In Wash Loop – How To Reset
Yes, there is a reset procedure to fix this. The Whirlpool Cabrio washers need to be reset in a different method than many other types and brands of washers. Here is how you can RESET your Cabrio washer (all Whirlpool Cabrio models). Follow the directions below and your washer should reset and begin to work normally. This reset procedure works on ALL Whirlpool Cabrio Washers that start with model number WTW.
How To Reset Whirlpool Cabrio Washer:
- Turn the washer off.
- Set the mode selector dial to NORMAL.
- Turn the dial counter clockwise ONE click (LEFT), clockwise THREE clicks (RIGHT), counter clockwise ONE click (LEFT) then clockwise ONE click (RIGHT).
- Now press the start button.
- All the cycle indicating lights should be illuminated.
- Press the Start Stop button once.
- Rotate the dial until Rinse, Wash, and Stop light illuminate.
- Turn the washer off and unplug it for 10 seconds.
- Finally, turn on the washer and it should now be reset.
- Run a test load empty to be sure the reset worked. If not perform the reset procedure one more time.
Whirlpool Cabrio Washing Machine Replacement Parts WTW
If that did not work, try the next Cabrio reset procedure:
- Touch any button on the display pad to clear the error code or press “Pause Cancel.”
- Choose another cycle and press “Start”.
- Disconnect the Cabrio from power if the error or problem comes back.
- Wait 5 minutes before restoring power.
- Choose a new cycle and press “Start.”
- Run a test load empty to be sure the reset worked. If not perform the reset procedure one more time.
Cabrio Washing Machine Diagnostic Test & Error Codes
If the second reset does not get your washer out of the endless wash cycle, please leave a comment below and explain in detail what the exact issue is and we will assist in troubleshooting.
Written by Keith Schneerer
Certified Appliance Tech · Founder, RemoveAndReplace.com
Keith has spent 30+ years repairing machines, starting as a military mechanic and later maintaining food processing equipment before moving into appliance repair. He founded RemoveAndReplace.com to share field-tested repair advice.
More about Keith →
Whirlpool cabrio platinum washer, received dL code, unplugged, resset, unplugged again, continues to receive code. Lock will not engage; I have thoroughly cleaned around lid, locking mechanism and still nothing. HELP!
I have tried both the resets and it will not even start a cycle..it tries and then I get Lid error.
Hi my washer won’t start it just make a nose like its draining and says 10 min on it I tried to reset it and still nothing
My Whirlpool washer model Wtw8500dc has an error code 8 on the screen.
It only clears if disconnected.
Once plugged back in it will show the same code and will not allow me to press any buttons.
My washing machine run thru all cycles fine but the clothes are still wet. It shows no error code, i just have to put it on drain and spin after the cycles. what can I do?
Dan,
Please recheck error code as F77 for Whirlpool Cabrio Washer is not in our database.
-RR
I have tried all sorts of instructions on how to reset the washer. I have not been able to!! Whirlpool is very unresponsive.