Here is information that will assist you in identifying what may be making your Amana washer display an error code. Identifying what the error or fault code is will help you to repair your washer. The Amana specific error fault codes below are to give you an idea as to what part is at fault. You may have to do further troubleshooting to find what may be causing the fault for that specific part. First try the solutions suggested here or visit www.amana.com/help for assistance and to possibly avoid a service call.
Amana Washing Machine Error/Fault Codes – Probable Fault Identifiers
“Sd”
(Excess suds)
F8 followed by E1
(water supply error)
F9 followed by E1
(drain pump system error)
F5 followed by E2
(door will not lock)
F7 followed by E1
(motor drive error)
“rL”
(remove load)
Washer making error beeps
Door has not been opened and closed for at least 3 cycles
Washer beeps when HOLD TO START is touched
Door not closed
F# E# code other than as described above appears in display
System Code Error
“nt” (interrupted)
Cycle was paused or cancelled
Clean Washer LED flashing at end of wash cycle
The washer has run 30 wash cycles and is indicating a reminder to run the Clean Washer cycle
If your Amana Washing Machine Error Code is not listed here, check
Google or YouTube to find the exact error code your Amana is displaying.
Here are error codes for Amana, Asko, Beko, Bosch, Daewoo, Fisher & Paykel, Frigidaire,
GE, Haier, Hotpoint, Kenmore, LG, Maytag, Samsung, and Whirlpool washers.
Here are Washing Machine Error Codes For All Washing Machines.
Need assistance with finding an error code for your washer?
Ask your question below and we will be happy to assist.
Written by Keith Schneerer
Certified Appliance Tech · Founder, RemoveAndReplace.com
Keith has spent 30+ years repairing machines, starting as a military mechanic and later maintaining food processing equipment before moving into appliance repair. He founded RemoveAndReplace.com to share field-tested repair advice.
More about Keith →
I just fixed this problem today. It turns out that an upside down capital letter f followed by e is a code for the thermistor. On your model you must remove the front panel and door and look at the bottom of the front of the tub. You’ll see a small black round plug with an orange and a white wire connected to it. After unplugging the washer, disconnect the plastic connector. Check the wires for continuity at each end (the other end goes into a small square shaped box in middle at the top of the washer under the lid that slides back.) then check the 2 metal probes coming out of the thermistor. If the wires have continuity, replace the thermistor.
We have Amana NFW7300 washer.
It stops and beeps (3 fast beeps) and the wash light blinks 9 times, pause then 2 times.
It’s a PITA pressing stop, open, power, etc until it does something then we can restart.
This is an intermittent problem.
Anyone have insight into what this error code (9, 2 or 2, 9) is?
Washer machine is showing E3 F6
i have an Amana frontloader washer door was locked. got the top off and released the door but all it does is hum. no codes are showing on the washer. how do i find out what code it is?
I have an owner of Amana Washer, NFW7200TW. My washer shows non-standard error code with (reversed F and E). Once I started it, water starts to fill but stop running after 10 – 15 seconds with a beep sound. What is the problem and how can i fix it?
UC Code on a Amana nah6800aww. Anyone have any ideas?
How do I get the error code to pop up! Washing machine will not spin or drain!